KitchenAid KHDD2 38510 Instruções de Utilização

Instructions for useGBIT

10Gas connection WARNING! This operation must be performed by a qualifiedtechnician.• The gas supply system must comply with local regulations.• You

11The cook top is designed to be built in to a work surface as shown in the figure.Before installing the cook top, install the gasket seal around the

12Note: Refer to the table on page 6 to ensure the correcttype of injector is to be fitted.Traditional burners (T)1. Remove the cap (A).2. Remove the

13Before any cleaning and/or maintenanceoperation, disconnect the hob from powersupply and wait until it is cold.To keep the hob in perfect condition,

14If the hob is not working properly work throughthe this guide before contacting our CustomerCare Centre.The burner does not ignite, or the flame isu

Whirlpool EMEA S.p.A. Via Carlo Pisacane n.1,20016 Pero (MI), Italywww.whirlpool.euPrinted in Italyr 10/16400010902980

Product description and symbols 4Using the burners 4Practical advice on using the hob 5Positioning the pan supports 5Hood and cabinetry clearances (mm

41. Removable grids2. Auxiliary burner3. Rapid burner4. Auxiliary burner control knob5. Rapid burner control knobProduct description and symbolsContro

5Read the instructions to get the best out of yourhob.- Use pans with a similar diameter to the burner(see the table on this page)- Use flat bottomed

6This appliance is not provided with a combustionproduct discharge. It is recommended that it beinstalled insufficiently aerated places, in terms ofth

7CategoryII2H3+Refer to the injector table of your CountryElectric supply:220-240 V ~ 50/60 Hz 0,6WInjectors tableType of gas usedType of burnerInjec

8• In the event of prolonged usage, additionalventilation may be required (opening a windowor increasing the extration speed of the hood).Warning• K

9ECO design declarationThis appliance meets the eco design requirements of European regulation N. 66/2014, in conformity to theEuropean standard EN 30